PRODUCTS
English
Use accurate torque controls to improve quality! Case examples can be found in torque handbook 10
GLOBAL HOMEHOME > Products > Tightening Assurance System > Tightening data control system for pneumatic tools
Tightening data control system for pneumatic tools
Information available on multiple units (nutrunners) that can be incorporated with torque sensors.
CD5
CD5 compact display is a digital display that shows values measured by the strain gauge sensor. Based on judgment results, the display changes its color in white/red/blue.
Display for strain gauge sensor.
PTA-G-BT
For labor-saving and high-accuracy tightening. Permits management of entire tightening torque data.
Labor-saving for tightening tasks from 2 to 10 N·m. * Two models in the series.
Automatic retrieval of tightening torque data reduces task load and prevents entry errors.
Detects two rounds of tightening to prevent this human error (Pokayoke).
Detects torque increase in insufficient rotation angles caused by “biting (seizure)” or the like during tightening.
Terminal block tightening operations. Terminal block screws: M5/M6 (PTA5N-BT) or M6/M8 (PTA10N-BT) * For tightening torque values, check the spec. sheet etc. provided by the terminal block manufacturer.
ST3-G/ST3-G-BT
ST3 is available in SI units in Japan. ST3-G CPT-G series products are manufactured for the global market and offer a selection of SI, metric and American units of measurement.
Checks nutrunner torque and angle on multi-spindle tightening equipment.
The ST3-G-BT series is especially useful for checking torque and angle for rotation angle tightening of a plastic region.
Often used to good effect as a measuring device (standard accessory) for multi-spindle equipment nutrunners.
Checks the torque and angle of angle power tools and hand nutrunners.
The ST1000N3-G model is ideal for torque checking (daily check) of TW2 series of torque wrenches used to tighten the wheel nuts of large vehicles, and the DQLE1000N2.
TPC/TPC2
The protocol converter connects Tohnichi products to systems that have other configured protocols
It establishes a system that can use a variety of tools to match the output format of Tohnichi products with production line nutrunner protocols.
It establishes a system for converting the output of Tohnichi’s Pokayoke (error-proofing) R-CM receiver to Ethernet.
Nutrunner backup system
It provides torque control for nutrunner tasks in difficult-to-reach confined spaces.
It is used for preventing human tightening errors (Pokayoke) and managing tightening torque data.
ME/MC2
For automation of multi-spindle tightening with a wide range of screws (M8 to M48).
For automatic tightening system / multi-spindle tightening system.
Use accurate torque controls to improve quality! Case examples can be found in torque handbook 10
